Why my Clarke PLS195 Pressure Washer will not draw chemicals?
If your Clarke Pressure Washer isn't drawing chemicals, start by cleaning the chemical filter. If the chemicals are too thick, dilute them to the consistency of water. Ensure you're using a longer supply hose instead of a longer high-pressure hose.
Why is my Clarke PLS195 leaking at the gun?
If you experience water leaking at the gun or spray wand connection of your Clarke Pressure Washer, check for worn or broken O-rings and replace them. Also, ensure the hose connection is tight.
Why is my Clarke PLS195 Pressure Washer leaking water from the pump?
If you notice water leaking at the pump of your Clarke Pressure Washer, tighten any loose connections. The piston packings, worn or broken O-ring, pump head or tubes damaged from freezing should be replaced by your dealer.
Why Clarke Pressure Washer pump pulsates?
If the pump of your Clarke Pressure Washer pulsates, clear the obstructed nozzle.
General| Brand | Clarke |
|---|---|
| Model | PLS195 |
| Category | Pressure Washer |
| Language | English |
Steps to attach wheels to the power washer axles securely.
Instructions for attaching the rubber feet to the machine's legs.
Procedure for connecting the spray wand to the lance.
Guide for securely connecting the high pressure hose to the spray gun.
Steps for connecting the high pressure hose to the power washer unit.
Instructions for connecting the water supply hose to the unit's water inlet.
Details on fitting the bracket for storing the hose and lance.
Includes removing travel plug, checking pump oil level, and general pre-use readiness.
Ensures correct engine oil and fuel levels, and identifies the recommended fuel type.
Defines terms like PSI, GPM, CU, Bypass mode, Thermal Relief Valve, and Chemical Injection System.
Follow engine manual for correct starting. Check fuel and oil levels, turn on water supply.
Pull trigger to start flow, grip firmly with both hands, expect kickback.
Warning against operating in bypass mode for more than two minutes due to overheating risk.
Instructions on how to change the spray pattern from narrow to wide.
Covers regulator, distance, RPM, and spray angle adjustments for pressure control.
Steps for applying cleaning solutions using the chemical injection system.
Details the recommended ratio for chemical solutions to water.
Steps for safely shutting down the unit, flushing the system, and preparing for storage.
Refer to storage section for proper procedures before storing the unit.
Procedure for drawing water from a water butt using the self-suction capability.
Steps to ensure consistent water ejection and high pressure output.
Note: Do not let the pressure washer run dry to prevent damage.
Instructions for draining old oil, replacing drain plug, and refilling with recommended oil.
Proper disposal of used oil at a local waste disposal site, not with household waste.
Steps to clear a clogged nozzle by disconnecting the spray wand and flushing with water.
The water inlet should be checked and cleaned periodically if necessary.
Covers engine, pump, and general storage procedures for the power washer.
Product must be disposed of according to WEEE regulations at a recognised disposal facility.
Troubleshooting steps for engine starting issues: check fuel, oil, spark plug wire, switch, and choke.
Resolving pressure loss: ensure water supply, check for leaks, clear nozzle/filter, check choke/throttle.
Diagnosing issues like air in hose, chemical draw problems, water/oil leaks, and pump pulsation.
Details on engine model, power, type, starting system, and fuel capacity for PLS195 and PLS265.
Specifies maximum feed temperature and minimum feed volume for water supply.
Includes working pressure, max pressure, water flow rates, sound levels, and vibration.
Provides length, width, height, and weight specifications for the power washer models.
To Next Page