9
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
REMOVE THE TRAVEL PLUG BEFORE USE.
1. Remove the red travel plug.
2. Inside the small bag attached is
an oil
filler cap which needs to be
fitted in its place.
BEFORE USE
IMPORTANT: The engine is supplied without any oil in it and must be filled to
the correct level before use, see below.
CHECKING THE PUMP OIL LEVEL
Look at the sight glass on the pump
to check the oil level inside.
If required, top up with oil. See
“Changing the pump oil” on
page 17.
• We recommend the use of
SAE30 oil in this pump.
WARNING: TO CARRY OUT THIS CHECK, PLACE THE POWER WASHER ON
LEVEL GROUND WITH THE ENGINE SWITCHED OFF.
WARNING: TAKE CARE NOT TO TOUCH ANY HOT PARTS OF THE POWER
WASHER WHEN CHECKING THE OIL LEVELS.
To Next Page
Loading...
Need help?
General
