Page 3 of 41
3.3.4 Oil Specification 24
3.3.5 Oil Capacities 24
3.4 COOLING SYSTEM 24
3.4.1 Intended Engine Operating Temperature 24
3.4.2 Engine Coolant 24
3.4.3 Water 24
3.4.4 Coolant Capacities 25
3.4.5 Coolant Inhibitors 25
3.4.6 Procedure for Filling Engine 25
3.4.6.1 Partial Fill 25
3.4.7 Providing Adequate Raw Water Supply to the Engine Heat Exchanger 26
3.4.7.1 Raw Water Supply 26
3.4.7.2 Cooling Loop 26
3.4.7.3 Setting Raw Water Flow Rate 27
3.4.7.4 Raw Water Outlet 28
3.4.7.5 Raw Water Quality, Strainers and Deterioration of Heat Exchanger (or CAC) 28
3.4.7.6 Backflow Preventers 28
3.4.7.7 Raw Water Outlet Temperature 28
3.4.8 Flow Paths of Engine Cooling System 28
3.4.9 Important Service Notice 29
3.4.9.1 Water Pump Cavitation 29
3.5 ELECTRICAL SYSTEM 29
3.5.1 Wiring Diagrams 29
3.5.2 Checking Drive Belt Tension and Adjustment 30
3.5.3 Speed Switch 30
3.5.4 Magnetic Pick-Up 30
3.5.5 Mechanical Engine Control and Alarm Board (MECAB) Speed Switch Troubleshooting 31
3.5.6 Field Simulation of Pump Controller Alarms 33
3.5.7 Battery Requirements 34
3.6 ENGINE SPEED ADJUSTMENT 34
4.0 MAINTENANCE SCHEDULE 34
4.1 ROUTINE MAINTENANCE 34
5.0 TROUBLE SHOOTING 35
6.0 PARTS INFORMATION 35
6.1 SPARES 35
6.2 ENGINE MAINTENANCE PARTS LIST 35
7.0 OWNER ASSISTANCE 35
8.0 WARRANTY 35
8.1 GENERAL WARRANTY STATEMENT 35
8.2 CLARKE WARRANTY 36
To Next Page
Loading...