Clas Ohlson LT3011A - During Treatment Operations

To Next Page

To Previous Page

14 15

English

6.9 Start the treatment and adjust the intensity

1. Press [CH1 +] or [CH 2 +] to increase the output intensity from 0 and

upward for channel 1 or channel 2 and in doing so, start the treatment.

2. Press [CH1 -] or [CH2 -] repeatedly to reduce the output intensity for

channel 1 or channel 2. Adjustment occurs in 1 mA increments.

3. The set intensity (mA) and the remaining treatment time are shown at

the bottom of the display.

The maximum treatment duration is 90 minutes.

Warning: Reduce the stimulation level if you experience discomfort.

Seek medical attention if the discomfort persists.

6.10 Pause the treatment

Press [ ] to pause the treatment. Press again to continue.

6.11 Switch off the machine

1. Press and hold [ ] for about 3 seconds to switch off. Note: Except for

working mode, the device will automatically turn off when no button is

pressed in 3 minutes.

2. Carefully remove the electrode pads from the body and ﬁt the protective

backing plastic. If the treatment is to be continued within a short time,

you may leave the electrode pads on the body.

3. Wash the skin with mild soap and water when the electrode pads have

been removed.

Store the electrode pads in a plastic bag.

Seek medical attention if the skin is irritated.

6.12 Quick stop

If you need to switch off the machine quickly:

Press [ ] to pause the treatment, press again if you wish to continue.

Note:

• The strength of stimulation must be adjusted individually for each user.

• The intensity can be adjusted from 0 (off) to max.

• Switch off the machine before the electrode pads are removed from the body.

• The intensity goes down to 0 automatically when the treatment is ﬁnished.

6.13 Keypad lock

Note: If you do not press any buttons for 20 seconds this will enable a

security lock/keypad lock that locks the buttons so that the intensity cannot

be increased and no button functions can be used without disabling the

keypad lock. A key symbol is shown on the display when the keypad lock is

enabled. To turn off the keypad lock: Press [CH1-] or [CH2-].