15
English
6.14 Check what is stored in memory
The machine saves different parameters in memory such as the memory
number of the treatment and its programme, treated body part, average
intensity and duration. A maximum of 30 treatments may be stored in
memory, after 30 treatments, the oldest is deleted and the most recent saved.
To check what is stored in memory: Press and hold [S] for 3 seconds to
open memory mode. Press [
] to read the various memory parameters.
Press [CH1] to go to the next memory number.
Note:
• The machine returns to standby mode when you press [
], or
automatically after 30 seconds.
• Press and hold [S] for 3 seconds to show the total number of treatments
in the memory, they are shown flashing on the display:
- Delete everything in memory: press [ ].
- Cancel deletion and return to standby mode: press [ ].
6.15 Battery warning
When the battery symbol flashes, the batteries should be replaced as soon
as possible. The machine will continue to work for a few hours before
shutting down.
6.16 Individual settings U1
In TENS and EMS modes there is a mode (U1) for programming your own
individual treatment settings.
1. Turn the machine on and select U1 by pressing [P].
2. Keep [P] held in to enter the settings mode for U1.
3. Select the desired parameters using [CH1-].
4. Adjust the selected parameter using [CH2+] or [CH2-].
- Adjust the pulse duration from 50 to 350 µs.
- Adjust the pulse frequency from 1 to 150 Hz.
- Adjust the treatment duration from 5 to 90 minutes.
5. Press [
] to confirm settings and enter standby mode.
Note: Reset U1 to default factory settings by holding in [CH2-] at the same
time as you insert the batteries.
To Next Page
Loading...