Clas Ohlson WS2068HL+WT450H User Manual

6
1
SET C/F
-
AA 1.5V+
-
AA 1.5V
+
2
4
6
3 5 7
1
1
1
1
%
1
1
SET C/F
-
AA 1.5V+
-
AA 1.5V
+
2
4
6
3 5 7
1
1
1
1
%
1
E N G L I S H
Starting Up
First set the wireless sensor transmitter so that the weather station receives a
radio signal from the sensor when it is activated.
Step 1: Setting the wireless sensor transmitter
1. Remove the battery cover and insert 2x LR6
batteries (not included), according to the
markings on the battery compartment.
2. Thehousecode(01H)willashonthe
display for 8 seconds.
3. Change the code by pressing [°C/°F]
(7)
repeatedly, setting 1 to 15.
4. Set all the wireless sensor transmitters (one
sensor is included) to the same setting,
press [Set] (6), the channel ( “1” on the left
sideofthedisplay)willashfor8seconds.
5. Change channel by pressing [°C/°F]
(7) repeatedly, setting 1 to 4, press [Set]
(6).
6. The humidity and temperature appear on the display.
7. Choose a temperature display in °C or °F by pressing
[°C/°F] (7).
8. Replace the cover on the battery compartment.
The normal setting for the house code and channel is “01”. Change the weather
station’s house code or channel if it receives signals from other neighbouring
transmitters or sensors.
Step 2: Programming the weather station (receiver/base unit)
Low battery warning
Weather station (receiver): A horizontal low battery warning symbol will appear
on the display.
Sensor transmitter: A vertical “low battery” warning symbol will appear on the
display.
1. Remove the battery cover and insert 3 x
LR6 batteries (not included), according to
the markings on the battery compartment.

Clas Ohlson WS2068HL+WT450H Specifications

General

Brand	Clas Ohlson
Model	WS2068HL+WT450H
Category	Weather Station
Language	English