EN 20
Handling
PLEASE NOTE!
■ For your own safety, inspect the device for damage each time before powering on.
Only use the device if it does not show any signs of damage!
■ Make sure that there are no large, sharp objects on the surface to be cleaned.
■ Observe the MAX marking on the dust collector. If the marking is reached during
use, the dust collector will need to be emptied. Empty and clean the dust collector
after each use. The fi lter must also be cleaned regularly to avoid overloading the
motor.
1. Select accessories as needed (see the “Accessories” chapter) and attach to the
device (see the “Assembly” chapter).
2. Switch the device on (suction level I) by pressing the On / Off switch (4) once. The
device will begin the suction process immediately. The operating light (3) fl ashes.
3. If necessary, suction level II can be switched on by pressing the On / Off switch
again.
4. Drive the device over the area to be cleaned.
5. After vacuuming, switch off the device by pressing the On / Off switch again.
Switch the device off after each cleaned surface, as this will signifi cantly in-
crease the operating time per battery charge. Charge the battery after use (see
the “Charging the battery” chapter).
6. For best results with the device, empty the dust collector (9) after each use and
clean if necessary (see next chapter).
Cleaning and storage
PLEASE NOTE!
■ The HEPA fi lter, fi lter holder and dust fi lter are not suitable for washing machines,
dishwashers or dryers! Only air dry. Do not use a hair dryer under any circumstances.
■ Never use corrosive or harsh cleaners to clean the housing. They can damage the
surfaces.
The HEPA fi lter may fade over time. This is normal and will not impact its func-
tionality.
Emptying the dust collector
1. Take the dust collector (9) out of the motor unit (E) (see the “Assembly” chapter –
“Remove / insert dust collector”).
2. Hold the dust collector over an open bin. Hold it as close to the bin as possible so
that the dust doesn’t scatter around it.
3. Pull the tab (8) on the dust collector forward slightly. The bottom of the dust collector
will open and the dirt will fall out.
4. To close, press the bottom on the dust collector. The tab should click audibly when
it closes.
To Next Page
Loading...
