Clear-Com ENCORE MS-702 User Manual

MS-702 TWO-CHANNEL MAIN STATION
2-1
INSTALLATION
1. Unpack the unit and inspect for any damage that may have occurred in
shipping.
2. Connect the proper AC mains cable.
3. Install the MS-702.
Note: For additional information, refer to the Clear-Com System Installation
Manual.
4. Connect the AC to the mains circuit.
Note: Information on the mains power requirement is given on the underside of
the unit.
5. Connect the intercom lines.
6. Set the two termination switches on the rear panel to on.
7. Set the option switches to the default (up) position.
8. Switch power on.
The blue talk button lights should be on and the two red short lights should
be off.
9. Set listen levels and sidetones.
Refer to the listen level and sidetone setting topics in the Operation section of
this manual.
10. The intercom system should now be operating properly.
Read the rest of this manual for further information.
2

Clear-Com ENCORE MS-702 Specifications

General

Brand	Clear-Com
Model	ENCORE MS-702
Category	Intercom System
Language	English