ICS-2003 INTERCOM STATION
1-12
Warning: All station selector reassignments take place immediately upon exiting this
function. Active talk and listen paths will be disconnected when their labels are
removed.
Assign Forced Listens
To add or remove forced listens:
1. Select “select source -> assign destinations” to choose a single source and assign
it to multiple destinations. Select “select destination -> assign sources” to
choose a single destination and assign multiple sources to it.
2. Choose a station or interface label.
3. A list of destination or source labels will be displayed depending upon the
assignment method selected. If the label(s) is already assigned to the selected
label, that label will be outlined. To change a label’s assignment status, select
the label and press “Enter.”
Change Input Level Gain
This menu adjusts the level of the audio signal sent to the frame. Use the
selectors to raise or lower the gain
Maintenance Menu
The Maintenance menu provides functions for technical personnel. For
information on the use of these functions, see the Maintenance chapter.
Listens Button (5)
Although not marked for the listen function, the center button (5) displays listen
labels on any display expansion panel (XPL-12 or XPL-22) connected to the
station. Momentarily pressing and quickly releasing the (5) button will cause all
XPL panels to display the listen labels assigned to the selectors. If the listen and
talk labels are the same, then there will be no change. The function will time-out
after 10 seconds.
Swap Button (9)
The station can support two sets of talk and listen label assignments for its
selectors. The Swap window (9) button alternates between the two sets; the
talk/listen windows display the labels for each. This effectively doubles the
selectors.
If talk/listen paths are latched on when windows are swapped, the paths will be
disconnected temporarily. When the windows are swapped back, the previously
latched paths will be re-established. Should the label appear in both windows
(not necessarily in the same position) the path will remain latched through the
swap.
Additionally, the station can be programmed to allow talks and listens to be
active in both windows simultaneously.
This function can be inhibited from the configuration program.
To Next Page
Loading...
Need help?
General
