ICS-2003 INTERCOM STATION
2-1
INSTALLATION
INTRODUCTION
This chapter describes the installation of the ICS-2003/ICS-2003T display
station, including:
• Station placement
• Wiring
•Mains AC power
• Adjustments
• Configuration
• Accessory panels
MOUNTING STATIONS
Locate all intercom stations at comfortable heights for operation and leave at
least 2 inches (51 mm) of clearance behind the rear of the station’s chassis to
allow for cable connectors.
Accessory panels, that are intended to expand or enhance station operation are
usually mounted next to or near the station with which they are associated. Leave
at least 2 inches (51 mm) of clearance behind the rear of the station to allow for
cable connectors.
Accessory panels can be located as far as 25 ft. (7.6 m) away from the station. A
6-ft. (1.8 m) cable is supplied to connect them.
WIRING
This section provides detailed wiring diagrams for all stations’ wiring systems.
Eclipse uses either a twisted, 4-pair transmission, a single-pair twisted, or a coax
scheme between the station and the frame using the industry standard RJ-45
connector. Refer to Installing an Eclipse Matrix System: An Overview for RJ-45
connector installation and use, and the type of cable needed for connection
between stations and frames.
Most stations have a DB-15M and an RJ-45 connector to connect them to the
frame. Stations with only a DB-15M connector include a kit containing one
DB-15F/RJ-45 adapter. The adapter allows the use of RJ-45 connectors on both
ends of the connection between the frame and the station.
Connections to external devices via the Miscellaneous connector, use the
included DB-15M connector to construct one or more cables to connect external
devices to the station.
Leave at least 2 inches
(51mm) of clearance behind
the station for connecting
cables.
2
To Next Page
Loading...
Need help?
General
