27
RS-602/622 BELTPACK
SETTINGS YOU CAN CUSTOMIZE
Table 1 shows the beltpack functions you can customize with onboard
controls. Note than each function is assigned a number, which you will
refer to for programming.
Table 1: Functions You Can Edit With Onboard Controls
Before you program the beltpack with the onboard controls, the
beltpack must be connected to an intercom line and receiving power,
and must not be connected to a computer.
You can program most functions to operate on channel A, channel B,
or both. However, some functions affect both channels. Table 1 shows
how the functions affect channels.
FUNCTION # NAME STATUS CHANNELS
Function 1 Mode Select 1,2,3,4 Both A and B
Function 2 Latch disable on or off A or B
Function 3 Talk disable on or off A or B
Function 4 Call-on-talk on or off A or B
Function 5 Electret mic (headset) on or off Both A and B
Function 6 Audible call (in earphone) on or off A or B
Function 7 Channel swap on or off Both A and B
Function 8 Channel exclusive on or off A or B
Function 9 Split-ear headset (RS-622) on or off Both A and B
Function A Adjust Microphone Gain variable Both A and B
Function L Locks out onboard access on or off Both A and B
To Next Page
Loading...
