29
RS-602/622 BELTPACK
Latch Disable, Function 2
A beltpack’s talk button normally latches when you tap it twice. If you
select to disable this function, the talk button does not latch.
This setting is recommended if you use the call-on-talk feature, which
causes the beltpack to send a call signal each time you press the talk
button.
To select “latch disable” for a channel:
1. Press and hold the setup button until the setup information window
displays a “P” and then release the button.
2. Repeatedly press the Call A button until “2” appears in the display.
3. Press the appropriate channel’s talk button (Talk A or Talk B) to
toggle “latch disable” either on or off for that channel.
• A channel’s talk light reveals the function’s status for that channel.
If the talk light is on, “latch disable” is on; if the talk light is off,
“latch disable” is off.
• You can set latch disable for one or both channels.
4. When you have made your selections, press the setup button to save
them and to exit setup, or press the Call A button to select other
functions to program.
If you do not press a button within five seconds, the beltpack exits the
setup program without making any changes.
To Next Page
Loading...
