Need help?Do you have a question about the Clearaudio Emotion and is the answer not in the manual?
Attaching the motor pulley to the motor shaft and mounting the turntable chassis over the motor unit.
Placing the turntable platter onto the bearing and leveling the unit using a gauge.
Aligning the tonearm and adjusting the cartridge tracking force according to manufacturer instructions.
Mounting the cartridge, aligning it parallel to the record surface and using an alignment gauge.
Information on warranty, retaining purchase receipt, and proof of purchase for service.
Remove platter and cover bearing hole during transport. Take off motor pulley to prevent damage.
Lubricate bearing every two years and use specific cleaning fluids for acrylic parts.
Attaching the motor pulley to the motor shaft and mounting the turntable chassis over the motor unit.
Placing the turntable platter onto the bearing and leveling the unit using a gauge.
Aligning the tonearm and adjusting the cartridge tracking force according to manufacturer instructions.
Mounting the cartridge, aligning it parallel to the record surface and using an alignment gauge.
Information on warranty, retaining purchase receipt, and proof of purchase for service.
Remove platter and cover bearing hole during transport. Take off motor pulley to prevent damage.
Lubricate bearing every two years and use specific cleaning fluids for acrylic parts.
General| Drive type | Belt drive |
|---|---|
| Platter material | Acrylic |
| Speed | 33 1/3, 45 RPM |
| Tonearm | Satisfy tonearm |
| Motor | Synchronous motor |
| Dimensions | 420 x 125 x 350 mm (W x H x D) |
To Next Page