User manual
Page 8 © clearaudio electronic GmbH, 2022-11
2.1
Place the pre-mounted chassis on your hi-rack or another suitable surface.
Pic. 3: Placing the
Ovation
on the Flat Pads
2.2
To avoid hum noises we recommend to ground the bearing. For that attach the supplied grounding
wire to the bearing cap with the existing screw.
Pic. 4: Grounding the bearing of the
Ovation
2.3
Please remove the protective seal from the bearing shaft and place two drops of the synthetic
bearing oil (Art. No. AC068 available through www.analogshop.de), on the ceramic bearing shaft.
Slip the bearing top onto the bearing shaft of the turntable.
Pic. 5: Bearing oil
To Next Page
Loading...
