10 P2543BA | 2021-01 Apex Tool Group
1
EN
3 Items Supplied
Inspect the product for shipment damage and ensure that
all items have been received:
• Correct product (without battery pack)
• Instruction manual
• Declaration of conformity
• Warranty
4 Transport / Storage
Transport or store in the original packaging. Disconnect the
power supply during storage. The packaging is recyclable.
Refer to the 9 Ambient conditions, page 12.
5 Product Description
Battery powered hand held nutrunner used for the tighten-
ing / loosening of threaded fasteners:
• Work Light for secondary okay/not okay visual feed-
back
• “Stay Alive” function prevents reboot during battery
pack change. Stay alive time = 20 sec.
• On-tool Digital Transducer and Servo provide critical
information and eliminate errors
• Connects easily over WLAN and Bluetooth 4.0.
Display/Run Screen
Default Settings:
LED Work Light
Default Settings:
LED
6 Before Initial Operation
Charge Battery Pack
Battery pack is supplied partly charged and must be
charged completely being used for the first time.
See Original Instructions Milwaukee charger.
Do not use any other battery packs / chargers than the
following:
Battery Pack 18 V
Index Description
1 Display
2 Function Keys
3 Output Drive
4 Work Light
5 LED showing OK or NOK
6 Reverse switch
7 Start Trigger
8 Battery pack
9 SD card
10 Micro USB-B Port
11 Socket + u-Guard (optional accessory)
White Green Red
Tool running OK rundown NOK rundown
Blue Green Red
Tool running OK rundown NOK rundown
LEDs Operating status Result
after fastening
cycle
Continuous
green light
Active OK
Continuous
red light
Active NOK
Flashing light
Green –
low frequency
Energy saver
mode
Off Sleep
If linking is selected on the controller:
Green flash-
ing light –
high frequency
Active/Setting:
Linking
Linking OK
Flashing red
light
Active/Setting:
Linking
Linking NOK
Order no. Capacity
T50-1000497 2,0Ah
T50-1000498 5,0Ah
Index Description
To Next Page
Loading...
