WIFi Ch Config
To set an address in memory to a
given channel. Setting a channel
where the address is permanent. This
can be done for two channels
maximum. This feature is mostly
useful for two cases:
CASE 1- When the hand held is
always dedicated to the same two
sensors on a vehicle (channel A & B).
CASE 2- For tractor-trailer fleets, we
usually fix the tractor and leave the
semi-trailers free for multiple swapping
possibilities. The fleets of tractor-
trailer, tractor sets the sensor (Channel
A) and left the other free channels for
frequent switching trailers.
IMPORTANT !
To fix a sensor it must previously be
acquired.
With the curser on Wifi Ch Config
press Cycle to enter the menu.
The following appears showing the
channels that are free.
To fix the channel, press Cycle ,
Free will change to Fix.
Acquire
Manual Mode
➔ Wifi Ch Config
➔A: 4BCE56 Fix
➔B: 4A11F8 Free
Press to go to B and t o
come back to A.
IMPORTANT !
The fixed channels will not appear
when acquiring. If you need to see the
fixed sensors, you need to change
them to Free.T
Acquiring in Fleet mode
When acquiring in the presence of
multiple instrumented tractors with
fixed sensors, only the semi-trailers
with free sensors will appear. You only
need to select the desired semi and
anchor it.
Use to select the desired
semi to anchor. Use to high light
and , ACQ
to confirm and exit.
IMPORTANT !
It is not possible to anchor a sensor on
a fixed channel.
9
To Next Page
Loading...
Need help?
General
