Clevo N550RN - Page 36

Disassembly
2 - 12 Removing and Installing the M.2 SSD Module
2.Disassembly
M.2 SSD Installation Procedure (for PM951 only)
1. Place the thermal pad on the module as shown (Figure 8a).
2. Insert the module in the computer
(Figure 8b).
3. Tighten the screw to secure it in place (Figure 8c).
1
Figure 8
M.2 SSD Module
Installation
a. Place the thermal pad.
b. Insert the module.
c. Tighten the screw.
2
3
a.
3
2
b.
c.

Thermal Pad
Be sure to place the thermal pad’s adhesive side down onto
the module surface.
The thermal pad needs to be cut (along the two markers as
shown) to fit the corresponding size of the module.
1

1. Thermal Pad
2. M2 SATA Module
•1 Screw