Clevo P375SM - Removing the Hard Disk Drive

Disassembly
Removing the Hard Disk Drive 2 - 7
2.Disassembly
Removing the Hard Disk Drive
The hard disk drive is mounted in a removable case and can be taken out to accommodate other 2.5" SATA hard disk
drives with a height of 9.5mm (h). Follow your operating system’s installation instructions, and install all necessary driv-
ers and utilities (as outlined in Chapter 4 of the User’s Manual) when setting up a new hard disk.
Hard Disk Upgrade Process
1. Turn off the computer, and turn it over and remove the battery (page 2 - 5).
2. Locate the Hard disk bay cover and remove the screw .
3. Slide the bay cover until the case markers align.
4. Carefully lift the bay cover off the computer (Figure 3c).
Figure 3
HDD Assembly
Removal
a. Remove the screw.
b. Slide the cover until the
case markers align.
c. Remove the bay cover.

3. Hard disk Bay
Cover
•1 Screw
1
3
2
3
a.
c.
1
3
2
b.
3