Clevo P375SM - Removing the VGA-2 Card

Disassembly
Removing the VGA-2 Card 2 - 21
2.Disassembly
Removing the VGA-2 Card
1. Turn off the computer, and turn it over to remove the battery (page 2 - 5), component bay cover (page 2 - 13) and
CPU (page 2 - 16).
2. The VGA-2 card will be visible at point on the mainboard (Figure 17a).
3. Remove screws - from the
heat sink in the order indicated on the label (and on the heat sink unit itself).
4. Carefully (it may be hot) remove the VGA heat sink .

9. VGA Heat sink
•7 Screws
1
2
8
9
a.
b.
2
3
4
5
1
9
6
8
7

Heat Sink Screw Removal
and Insertion
Remove the screws from the
heat sink in the order indicated
here:
7 - 6-5-4-3-2-1 .
When tightening the screws,
make sure that they are tight-
ened in the order:
1-2-3-4-5-6-7 .
Figure 17
VGA-2 Card
Removal
a. Remove the screws.
b. Remove the VGA heat
sink.

Caution
The heat sink, and video
card area in general,
contains parts which are
subject to high tempera-
tures. Allow the area
time to cool before re-
moving these parts.