Clevo P375SM - Installing the VGA-1 Card

Disassembly
Removing the VGA-2 Card 2 - 23
2.Disassembly
Installing the VGA-1 Card
1. Do not forget to replace the master and slave cable if you are replacing two video cards.
2. Prepare to fit the VGA card
into the slot by holding it at about a 30° angle.
3. The card needs to be fully into the slot, and the VGA card and socket have a guide-key and pin which align to allow
the card to fit securely. Fit the connectors firmly into the socket, straight and evenly.
4. DO NOT attempt to push one end of the card in ahead of the other.
5. The card’s pin alignment will allow it to only fit one way. Make sure the module is seated as far into the socket
as it will go (none of the gold colored contact should be showing). DO NOT FORCE the card; it should fit without
much pressure.
6. Replace the master and slave cable by connecting it to the two VGA cards (if applicable).
7. Secure the card with screws & .
1
2
3
4
a.
1
b.
2
4 3

1. VGA-1 card Module
Figure 19
VGA-1 Card
Installation
a. Carefully Insert the VGA
Card.
b. Tighten the screws.