Clevo P375SM - Page 48

Disassembly
2 - 24 Removing the VGA-2 Card
2.Disassembly
8. Remove the sticker from the heat sink (Figure 20c).
9. Hold the VGA heatsink-2
by the tab and insert it back on the card (page 2 - 21).
10. Remove the sticker
from the heat sink (Figure 20d).
11. Hold the VGA heatsink-1
by the tab and insert it back on the card and
12. Secure screws - in the order indicated in (page 2 - 21).
13. Reinsert the component bay cover, and secure with the screws as indicated in (page 2 - 13).
5
6
10
11
9
15
c. d.
5
8
9
6
7
15
13
14
12

Heat Sink Screw Removal
and Insertion
Remove the screws from the
heat sink in the order indicated
here:
7 - 6-5-4-3-2-1 .
When tightening the screws,
make sure that they are tight-
ened in the order:
1-2-3-4-5-6-7 .
11
10
d.

6. VGA Heat sink-2
11. VGA Heat sink-1
•7 Screws
Figure 20
VGA-1 Card
Installation (cont’d)
c. Remove the sticker from
the heat sink-2 and In-
sert the VGA heat sink-
2.
d. Remove the sticker from
the heat sink-1 and In-
sert the VGA heat sink-
1.
e. Tighten the screws.