Clevo W330AU - Removing the Click Board Module

Disassembly
2 - 14 Removing the Click Board Module
2.Disassembly
Removing the Click Board Module
1. Turn off the computer, remove the battery (page 2 - 5), and bottom case (page 2 - 6).
2. Carefully disconnect cables & , then remove screws
& from the module (Figure 7a).
3. Lift the click board module (Figure 7b) up and off the computer.
Figure 9
Click Board Module
Removal
a. Disconnect the cables
and remove the screw.
b. Lift the click board out.
1
2
3
4
5

5. Click Board Module
•2 Screws
a.
2
3
1
5
b.
4