Clevo W330AU - Removing the CCD Module

Disassembly
2 - 18 Removing the CCD Module
2.Disassembly
Removing the CCD Module
1. Turn off the computer, remove the battery (page 2 - 5).
2. Turn the computer over and open the LCD,
3. Insert your fingers under the frame of the LCD at the point
and lift it up around 10~15 degrees and then slide
your finger along the inner frame towards points
& to separate it from the LCD (Figure 13a).
4. Remove the LCD front panel from the LCD (Figure 13b).
5. Disconnect the cable (Figure 13c).
6. Remove the CCD module off (Figure 13d).
Figure 13
CCD Module
Removal
a. Insert your fingers to lift
the frame up around
10~15 degrees and then
slide your fingers along
to separate the frame
and LCD.
b. Remove the LCD front
panel.
c. Disconnect the cable.
d. Remove the CCD mod-
ule.
1
2
3
4
5
6
5
b.
a.
2
3
1
6
d.
c.
4
2

4. LCD Front Panel
6. CCD Module