BIOS Utilities
5 - 8 Advanced Menu
5
SATA Mode (Advanced Menu)
The SATA (Serial ATA) control is configured to operate in AHCI (Advanced Host
Controller Interface) mode.
Boot Logo (Advanced Menu)
Use this menu item to enable/disable the Boot Logo screen at system startup if you
have not enabled UEFI Boot. If you disable the Boot Logo you will not see the F2
Enter Setup or F7 Boot Options prompts on the screen, however you can still press
these keys, while the boot screen is displayed, to perform the Enter Setup or Boot
Option functions.
Power On Boot Beep (Advanced Menu)
Use this menu item to enable/disable the beep as the computer starts up.
Battery Low Alarm Beep (Advanced Menu)
Use this menu item to enable/disable the battery low alarm beep.
UEFI Boot
When UEFI Boot is en-
abled, then the prompts
to press F2 or F7 will
not appear. However
you can still press F2 to
enter the setup, or F7 to
choose the preferred
boot device, if you
press the key immedi-
ately the system boots
up.
To Next Page
Loading...
