33
OPERATION
Temporary Manual Override
To temporarily change the current set temperature without aecting your program:
■ Press or and hold for about 1 second to enter
Manual Override mode. Display will ash.
■ Press or to change to your desired new tem-
perature.
■ Press to return to normal mode, or wait 5 seconds for it to return auto-
matically.
■ The current program number will ash to signify the Temporary Over-
ride.
■ At the next program change, the Temporary Override is canceled,
and the next program temperature becomes the setpoint tem-
perature.
To end the Temporary Manual Override:
■ Press to return the set temperature to the current program set temperature.
NOTE: The Auto Season Changeover feature6will not operate while the thermostat is in Temporary Manual Over-
ride. Refer to the Auto Season Changeover feature on page 39 for more information
.
NOTE: If Vacation Hold is set, then the number of days remaining will also be displayed. Refer to the Vacation (Pro-
grammable) Hold section on page 38 for more information.
ret/clear
ret/clear
To Next Page
Loading...
