Climbing Technology ALPINE UP - Dynamic Mode: Safe Operation in Case of Error; Error Handling and Safe Lowering; Dynamic Mode: Top Rope Belaying the Second; Top Rope Belaying Setup and Safety

Climbing Technology by Aludesign S.p.A. via Torchio 22
24034 Cisano B.sco BG ITALY www.climbingtechnology.com
8/24
IST12-2D651CT_rev.8 10-21
In case of error stop the ascent
and lower the climber.
14.1
SAFE LOWERING
14.2
SAFE LOWERING
Place the rope in the braking
groove A, accompany it
towards the device and lower
the climber.
Place the rope in the braking
groove A, accompany it
towards the device and lower
the climber.
14
DYNAMIC MODE
SAFE, EVEN IN CASE OF ERROR
NO!
During belaying at all times hold the free end of the rope
in your hand!
15.1
SETUP
15.2
BELAYING
15.3
WARNING!
Before starting climbing,
setup the system as in
12.1÷ 12.4.
With one hand pull the free end
of the rope through the device;
with the other pull the climber’s
rope towards the device.
During the belaying
(15.1÷15.2) hold fi rmly the
free end of the rope in your
hand at all times!
15
DYNAMIC MODE
BELAYING THE SECOND IN TOP ROPE