Climbing Technology ALPINE UP - Dynamic Mode: Installation and Setup; Dynamic Mode Setup Procedure; Dynamic Mode: Belaying the Leader; Dynamic Mode Leader Belaying Operations

Climbing Technology by Aludesign S.p.A. via Torchio 22
24034 Cisano B.sco BG ITALY www.climbingtechnology.com
7/24
IST12-2D651CT_rev.8 10-21
This mode is ideal for use on traditional climbing
routes with temporary anchors.
12.1
SETUP
12.2
SETUP
12.3
SETUP
12.4
SETUP IS OK!
Connect the
karabiner to the
belay loop of the
harness.
Insert the loop of the rope in
the slot B, referring to sym-
bols 2-7-8 on the device.
Insert the karabiner at right
angles to the lever H in the
hole G with the rope inside.
Close the karabiner gate!
The system is OK.
From now on always hold
fi rmly the free end of the
rope in your hand!
12
DYNAMIC MODE
INSTALLATION AND SETUP
NO!
Attention! A safety check between the climber and the belayer is essential before start climbing!
13.1
GIVING SLACK
13.2
TAKING UP SLACK
13.3
ARRESTING A FALL
13.4
LOWERING
13.5
WARNING!
With one hand, bend the free
end of the rope, with the other
pull and feed the climber’s
rope through the device.
With one hand pull and feed the
free end of the rope, with the other
pull the climber’s rope towards
the device.
Hold the free end of the rope
fi rmly in one hand and pull it
downwards. Don’t hold the
device in your hands!
Grasp the rope fi rmly with both
hands and move them alter-
nately downwards to lower the
climber to the ground.
During the belaying (13.1
÷13.4) hold fi rmly the free
end of the rope in your hand
at all times!
13
DYNAMIC MODE
BELAYING THE LEADER