Climecon CLEANMASTER Series - Installation of Grease Filters and Locking the Slidesafe Safety Lock

www.climecon.fi
© Climecon
2
3
1
10
Lämmittäjänkatu 4 A, FI-00880 HELSINKI, Finland · Telephone +358 20 198 6600, Fax +358 020 198 6609
1. First install the grease filters at far
edges, leaving the second grease filter
from the left as the last. Install also
the grease pans at the bottom of the
exhaust air chamber.
2. Move the grease filter on far left more
to the right.
3. Lock the SlideSafe safety lock by first
lifting the hand screws to the upper
position and then tightening the
screws.
NOTE! The CleanMaster® system will
not start, when the SlideSafe safety
lock has not been properly locked.
3.6 Installation of grease filters and locking the SlideSafe safety lock