Climecon CLEANMASTER Series User Manual

www.climecon.fi
© Climecon
2 3
4
5
1
18
Lämmittäjänkatu 4 A, FI-00880 HELSINKI, Finland · Telephone +358 20 198 6600, Fax +358 020 198 6609
1. Shut down the CleanMaster® system by turning the main switch of the CCM control system
to OFF position.
2. Open the safety locking of grease filters by loosening the hand screws on the left side of the filters.
3. Slide the hand screws to the lower position. NOTE! If the CleanMaster® system was not shut
down from the CCN control unit as instructed, the CleanMaster® system will now shut down
automatically.
4. Move the grease filter on far left more to the left.
5. First remove the second grease filter from the left and then the other grease filters.
Grease filters are machine-washable. Clean the exhaust air chamber if necessary.
6.3 Replacing the fluorescent tubes in the lights
1. Open the covering glass of the lights by opening the fixing screws.
2. Replace the fluorescent tubes.
3. Check that the gaskets are in good condition.
4. Re-install the covering glass.
6.2 Removing the grease filters

Climecon CLEANMASTER Series Specifications

General

Brand	Climecon
Model	CLEANMASTER Series
Category	Ventilation Hood
Language	English