www.climecon.fi
© Climecon 12
Lämmittäjänkatu 4 A, FI-00880 HELSINKI, Finland · Telephone +358 20 198 6600, Fax +358 020 198 6609
When the UV system has been switched on,
the UV lamps are preheated for 12 seconds.
During the preheating a yellow LED is illumina-
ted on the right side of the display.
After the preheating, the UV system starts to
function normally.
At this stage all UV lamps are on and a green LED
is illuminated on the right side of the display.
If any of the UV lamps stops working due to a
defect or a fault, the UV system display informs
about the lamp fault.
At this stage the faulty UV lamp should be checked
and replaced, if necessary.
New UV lamps should always be ordered directly
from Climecon customer service!
To Next Page
Loading...
Need help?
General
