www.climecon.fi
© Climecon 16
Lämmittäjänkatu 4 A, FI-00880 HELSINKI, Finland · Telephone +358 20 198 6600, Fax +358 020 198 6609
5.1 Functions of the control panel of the CCM control unit
5.2 Fault conditions of the CleanMaster® system
In a fault situation, the colour of the display of the CCM control unit and the colour of LED lights
change into yellow or red, depending on the situation:
ON/OFF
INFO
ARROW
DOWN
MENU
REMOTE
• changes the display screens
(Main Menu, filtering hours/
operating time/hours, meter
screen, depending on settings)
• cursor up in menu
• changes values (higher)
• to On/O menu
• cursor to the right
• cursor down in menu
• changes values (lower)
• to menus
• selection of a function
• confirms a change
• local/remote operation (NOTE! the display should read ”local”)
• cursor to the left
Functions of the keys:
5. OPERATING INSTRUCTIONS FOR
CLEANMASTER® HOODS
YELLOW LIGHT
Text on the screen: lamp age warning
The service hours of the UV lamp are approaching the end.
Order a new UV lamp from the Climecon customer service, tel. 020 198 6600.
Text on the screen: lamp age exceeded
The service hours of the UV lamp have been exceeded. Replace the old UV lamp with a
new UV lamp ordered from Climecon. See the instructions for replacing the UV lamp in
subsection 6.4.
RED LIGHT
Text on the screen: lamp age exceeded
The service hours of the UV lamp have been exceeded. Replace the old UV lamp with a
new UV lamp ordered from Climecon. See the instructions for replacing the UV lamp in
subsection 6.4.
To Next Page
Loading...
