4.1.4. Fresh water temperature probe CO
Each MV8 controller is supplied with a fresh water (CO) temperature sensor which must be electrically
connected to the CO terminals of the board. The eye-shaped sensor is instead fixed to the hose connector of
the fan coil, at the water inlet of the chiller circuit.
4.1.5. Probe CO on Fan coil – Fan only configuration
4.1.6. Probe CO on Fan coil – Water valve configuration
4.1.7. Multiple MV8 controls with a single digital control panel
It is possible to use a single control panel to manage a series of Climma Fan Coils of any model and which
are installed to condition the same ambient. The control panel must be connected to a single MV8 controller.
Each MV8 controller must be powered but only one must have the fresh water (CO) temperature sensor
To Next Page
Loading...