CLIVET RG66B3 - Advanced Functions: ECO, SLEEP, Follow Me, Silence, 8°C Heat; ECO Function; SLEEP Function; Follow me Function

“”
”
13
The Follow me function enables the
remote control to measure the temperature
at its current location and
.
When using AUTO, COOL, or HEAT modes,
measuring ambient temperature from the
remote control (instead of from the indoor
unit itself) will enable the air conditioner to
optimize the temperature around you and
ensure maximum comfort.
send this signal
to the air conditioner every 3 minutes interval
Follow me function
ECO function
SLEEP Function
The SLEEP function is used to decrease
energy use while you sleep (and don’ t
need the same temperature settings to
stay comfortable). This function can
only be activated via remote control.
Note:
The SLEEP function is not
available in FAN or DRY mode.
How To Use The Advanced Functions
For the detail, see sleep operation in
USER’ S MANUAL.
NOTE: This function is only available under
COOL mode.
Used to enter the energy ecient mode.
Under cooling mode, press this button,
the remote controller will adjust the
temperature automatically to 24°C, fan
speed of Auto to save energy(but only
if the set temperature is less than 24° C).
If the set temperature is above 24° C ,
press the ECO button, the fan speed
will change to Auto, the set temperature
will remain unchanged.
“
NOTE:
Pressing the ECO button , or modifying
the mode or adjusting the set temperature
to less than 24° C will stop ECO operation.
Under ECO operation, the set temper -
ature should be 24°C or more. it may
result in insucient cooling. If you feel
uncomfortable, just press the ECO
button again to stop it.
Hold down Fan
button for 2
seconds to activate
Silence function
Press this button
twice in one second
O
to activate 8 C
heating function
Hold down Eco
button for 2 seconds
to activate/cancel
SLEEP function.
O
8 C Heating Function
When the air conditioner operates under
heating
mode with the set temperature
O
of 16 C, press Temp button twice in
one second will activate 8 Degree heating
function. The unit will operate at a setting
O
temperature of 8 C. The indoor unit
display shows FP . For some units,
O
press this button can activate 12 C
heating feature, please refer to the
Owner s Manual of the air conditioner.
,,
,,
,,
,,
,
Silence function
Hold down Fan speed button for 2 seconds
to activate/cancel Silent mode. Due to low
frequency operation of compressor, it may
result in insucient cooling and heating
capacity. (applicable to the air conditioner
with Silent feature only)