7
Operate in compliance with safety regulations in force .
For detailed information (dimensions, weight, technical cha-
racteristics etc.) please refer to the “Technical information”
section.
Use single protection devices : gloves, glasses ecc. .
2.1 PRELIMINARY INFORMATION
2.2 DELIVERY CONTROL
2.3 STORING
Use protection to avoid the unit damaging .
A
B
2- RECEPTION
Be careful not to damage the unit.
Recycle and dispose of packing material in conformity with
local regulations.
Observe external packing instructions .
2.4 HANDLING
Verify unit weight and handling equipment lifting capacity .
Identify critical points during handling (disconnected routes,
flights, steps, doors).
Before handling verify that the unit keeps its balance.
2.5 PACKING REMOVING
Before accepting the delivery you have to check:
• That the unit hasn’t been damaged during transport.
• Check that the materials delivered correspond with that
indicated on the transport document comparing the data
with the identification label ‘A’ positioned on the packa-
ging.
In case of damage or anomaly:
• Write down on the transport document the damage
you found and quote this sentence: "Conditional
acceptance — clear evidence of deficiencies/
damages during transport".
• Contact supplier and the carrier by fax and registered
mail with advice of receipt.
Any disputes must be made within the 8 days following the
delivery. Complaints after this period are invalid..
1
2
1 safety rods
2 pins
To Next Page
Loading...
Need help?
General