CLIVET WSAT-XEE 802 User Manual

10
4.7 RECOMMENDED CONNECTION
P
9
11
14
8
F
2
3
5
12
7
6
4
8
1
10
13
P
7
1. Charged system pressure switch
2. vent
3. circulating pump / pump
4. expansion tank
5. safety valve
6. flow switch
7. pressure switch / thermometer
8. filter
9. filling valve
10. antivibration joints
11. user side exchanger
12. Differential pressure switch
13. Discharge cock
14. inertial storage tank
4.8 VICTAULIC CONNECTIONS
 Take away the supplied connection union by acting on the
connection joint.
 Weld the union to the installation pipe.
 Perform the connection between the installation pipe and
the evaporator, using the joint.
Do not weld the system pipe with the connection joint
attached.
The rubber gasket might be irreparably damaged.
4.9 RECOVERY EXCHANGER
OPTIONAL
The unit can be equipped with exchangers to recover the
condensation heat.
The customer is responsible for the management of the
circulation pump, valves, thermostats, etc
The recovery input water must not be below 25°C, in the
event that, wrongful operations and breakages of the unit can
occur .
Water connections must be performed carefully as for the
evaporator (filter, circuit washing, etc) .
Perform all necessary interventions to avoid the RISK OF
FREEZING (tubes insulation, emptying of circuit, addition of
glycol, anti-freeze resistances) .
Water temperature can reach high temperatures (up to 100°
C), therefore:
 avoid the RISK OF BURNS by adopting the
necessaryprecautions (insulation of tubes, temperature
detecting station on water if the sanitary use is foreseen,
etc).
 Install safety valves and specifically dimensioned
expansion tanks in the hydraulic circuit.
4 - WATER CONNECTIONS
4.10 OPTION CONNECTIONS FLUSH THE UNIT
A - standard unit
B - Unit with ABU option

CLIVET WSAT-XEE 802 Specifications

General

Brand	CLIVET
Model	WSAT-XEE 802
Category	Chiller
Language	English