THROTTLE CONTROL
You have a range of 1-250 to adjust your speed. This does not correlate to
your actual GPS speed. Use an external GPS in order to get an accurate speed
reading for your situation.
Speed Adjustment
There are two buttons to control your speed, a rabbit icon for increasing
your speed and a turtle icon to decrease your speed. Press one time on the
corresponding button to change your speed in single increments.
Jog
If you hold down on either speed button for four seconds your increments
will increase by 10. Release the button and then press once again to go back
to increasing by single increments.
Feature buttons
These two buttons will allow you to max out the throttle control [approx.
80% of factory throttle], or return to idle.
Max Throttle
To use this feature you need to depress and hold the Max Throttle button. You
will see ‘Max Throttle’ appear on the screen while it is being held down, and your
motor will increase speed and stay at that Max Throttle as long as the button
is held down. To return to your previous speed setting, release the button.
Idle/Resume
To use this feature press the Idle button. When you do, the throttle will drop
to the 000 setting and it will say ‘Idle 000’ on the remote. To resume your
previous setting press the Idle button again. You will see ‘Resume XXX’. The
XXX will be the setting you had last been congured for.
STEERING CONTROL
When your unit is connected to a Panther Electro Steer (sold separately,) you
are able to remotely steer your kicker motor. Press once on the Left or Right
Arrow button on the remote to move in small increments. If you hold down the
button it will move in larger increments. See Installation Steps for more details.
Page 5
To Next Page
Loading...