Need help?Do you have a question about the CMP TROLLMaster PRO3+ and is the answer not in the manual?
Connects the red 16AWG to the positive 12V battery terminal and black 16AWG to the negative terminal.
Connects the red 18AWG wire to switched accessory power at the helm station for operation.
Used for attaching a Panther Electro Steer unit; push connector until snug and ends meet.
Secure the receiver using mounting holes, ensuring cables reach their destination and the unit is stable.
Step-by-step setup from servo installation and wiring to remote pairing and initial operation.
Instructions for powering the remote on, off, and how it enters sleep mode automatically.
The remote uses two AAA batteries; a low battery indicator will signal when replacement is needed.
Control speed with incremental buttons or hold for faster 10x increments.
Set max throttle or return to idle; resume previous setting with a second press of the idle button.
Remotely steer the kicker motor using arrow buttons for incremental adjustments.
Place receiver in a protected spot, route wires, and secure it using mounting holes.
Connect main power to 12V battery and ACC+ to a switched helm power source.
Route servo wire to the kicker motor servo, avoiding spark plug wires for EMI reduction.
Route steering cable, connect 2-Way molded connector. Reverse polarity if steering is reversed.
Pair remote by pressing receiver button, then remote button. Light indicates status.
Addresses no servo/steering response, checking power, pairing, and signal line of sight.
One-year warranty for defects; requires proof of purchase. Excludes damage from misuse or accidents.
Lists damages not covered, including accident, abuse, poor installation, and consequential damages.
Extension allows greater freedom of movement than standard lanyard for engine shut-off.
Adjust steering friction to prevent unintended engine turns, especially on tiller steering.
States compliance with FCC Part 15 and Industry Canada RSS standards for device operation.
Offers motor mounting, steering, tilt/trim, anchors, and security systems.
Provides rod holders, trolling motor supports, and GPS/Sonar mounts.
Offers auxiliary outboard motor steering systems.
Provides throttle control for gas-powered auxiliary motors.
General| Brand | CMP |
|---|---|
| Model | TROLLMaster PRO3+ |
| Category | Remote Control |
| Language | English |
To Next Page
