2
■Requirements for the configuration of master control computer:
①The desktop computer must possess parallel ports; Notebook PC or USB parallel port cannot be
used normally.
②Minimum configuration of the computer: CPU/1G, 512M memory, 20G hard disk, mainboard with
parallel port, WIN-XP operating system.
■Introduction to control software and design software:
①Control software: Mach3 is recommended (EMC2 and Kcam4 can also be applied, and consult
software providers for detailed information);
②Design software: ARTCAM, PowerMill, and TYPE are commonly used, but there are also many kinds
of other professional software.
------------------------------------------------------------------------------------------------------------------------------------------------
Important statement: we only sell engraving machine, but not including
computer and relative software. The software mentioned in this manual is
only for your convenience, so please understand, select, purchase, and use
the software on official software website in accordance with your needs.
------------------------------------------------------------------------------------------------------------------------------------------------
To Next Page
Loading...
Need help?
General
