Congratulations! You already have your own numerical control engraving machine,
but you need to carefully know it and master it, in order to make it your good
assistant as soon as possible.
■Read before using:
●This machine is only designed for the surface engraving of plastics, bamboo and timber, and non-
ferrous soft metal, so the application with other purposes may damage it;
●Before using this machine, one must wear protective goggles, to avoid the damage from scrapping
eruptions;
●Do not try to disassemble the machine or electric cabinet for reconstruction or fixing, otherwise it is not
under warranty;
●Please pay attention to the electricity safety as other electric appliances, use ratified standard voltage,
and make sure that its electrical grounding is safe;
●Do not place the machine in moist or dusty environment, and do not let children get close to or touch it;
●Timely cleaning and periodic maintenance can keep the engraving machine in good operating state,
and also lengthen its service life;
●This engraving machine is a mechatronics processing tool, so operators should grasp relative
professional knowledge to be proficient in using this machine;
●This manual only provides instructions to the application environment and operation requirements of
this machine, while not involving other professional knowledge that relate to control computer, software,
and materials. Please ask for help from your suppliers if you have any problems in these aspects.
■Basic workflow of engraving machine:
①Install "control software Mach3" on the desktop computer, and setup parameters for the control
software in accordance with the requirements of engraving machine;
②Design the content that needs to be engraved through design software, and output G code or nc, Tab
files that can be recognized by Mach3;
③Firmly clamp the materials need to be engraved on the operating platform of engraving machine;
④Import engraving code to the control software Mach3, send out command to the engraving machine
after passing through the code, and then the engraving machine will start to operate.
1
To Next Page
Loading...
Need help?
General
