Mach3 USB Motion Card STB4100 V2.1
2.6 Mach3 MPG Setup:
Note: The electronic handwheel selection 5V voltage output models, more than 5V output will
damage the hand wheel interface, refer to the following wiring diagram:
Mach3 MPG Setup:
The Mach3 Menu => Config =>Ports and Pins=>Encoder/MPG’S
Press the ”Tab” key on your keyboard, to bring up the “MPG MODE” mach3:
Pick tick “√”
After setting, click "Apply" to
save the setting results
To Next Page
