UC100
USB CNC motion controller
to use with MACH3 software
Current plugin version: V2.133
Contents:
1. Product description and background of working.
2. Installation of the USB drivers and the plugin.
3. System setup.
a.) The first run.
b.) Setting up Mach3 with the UC100 controller .
4. LED feedback signals on the UC100 controller.
5. Errors and installation debugging.
6. DSUB-25 connector pinout.
7. Known limitations and bugs.
8. Parameters and functions summary.
9. Safety notes.
To Next Page
Need help?
General
