5. Errors and installation debugging
If the following screen pops up when starting Mach3:
then the .NET framework was not installed on the computer. The .NET framework 2.0 is
the prerequirement for running the UC100 controller plugin. The framework can be
downloaded from Microsoft's website. The .Net framework 2.0 is part of Windows7 and
therefor it is not required to install it on Windows 7 operating systems. It is only required to
install it on Windows XP as it not containing this tool by default, it must be installed
separately, by the user on the Windows XP operating system.
The following popup screen indicates that Mach3 is unable to establish the connection
with the UC100 controller, check the USB connections and the LED states of the UC100
and restart Mach3.
If the error does not go away then check and if nessessary reinstall the USB drivers.
The following popup screen appears if Mach3 loosing the connection with the UC100
meanwhile it is operating. This event may happen if the USB cable is broken or if the cable
connector was accidentally slipping out from the UC100 or from the PC. The workaround
is checking the USB cable connections and plug it back and restart Mach3.
To Next Page
Loading...
Need help?
General
