CO/Tech MBY8-UK - Motor Cover; Tips for Use

9
ENGLISH
10Q
10P
11. Motor cover
The plane is equipped with amotor cover which is triggered automatically and in that way stops theplane if
themotor overheats due to overloading. Themotor cover can only be reset by hand after themotor has cooled
down. Letit stand for 15–30 minutes. Themotor cover sits on one end near theemergency stop.
If you believe themotor cover has been released do as follows:
1. Press theemergency stop (P).
2. Raise thecutter and remove thematerial being planed.
3. Wait for 15–30 minutes until themotor has cooled down.
4. Press thereset button (Q).
5. Try starting themotoragain.
12. Tips for use
1. Read thewarning text carefully before using theplane.
2. Fasten theplane onto astable base at agood height.
3. Set desired planing height with thecrank and theextraction hose.
4. Plug into wall socket.
5. Press thegreen button (1) on thepower switch to start themotor.
6. Test-run theplane on apiece of board. Measure theresult and adjust according to requirement.
7. Use theroll support if thework material islong.
8. Turn theplane off: Press(0) thepower switch, press emergency stop and pull out theplug when
theoperation is finished.
9. Tidy theworkplace.
13. Care
Inspection and changing of carbon brushes
Attention! Presstheemergency stop and pull out theelectrical cable plug before inspecting thecarbon brushes.
• Regularly check thecarbon brushes and change them if thelength is below 5mm.
• Change thecarbon brushes inpairs.
• Keep thecarbon brushes clean and make sure they can move freely in thecarbon holder.
Cleaning
Always brush away dirt, shavings and foreign objects on feeding rollers and in ventilation holes and cables.
Makesure that oil or water does not get into themotor.
Greasing
Grease thefour spindles on theplaning table regularly with lubricant (WD 40, 556 etc.) to prevent them from
drying out.