CO/Tech MOR-LR01-370 User Manual

8
ENGLISH
12
4.3 Starting and stopping
• NOTE: Startthemower only when your hands and feet are asafe distance from therotating blade.
• NOTE: Theblade will continue to rotate ashort while after themotor has been turned off. Always let
themotor/blade come to acomplete stop before starting themotor again.
Start
1. Insert thesafety key (15).
2. Press and hold thesafety button (6) and then clasp thecontrol lever (7) against thehandle.
Note: Therewill be slight delay before themotor actually starts. Oncethemotor starts you may then begin using
themower.
Stop
1. Release thecontrol lever (7) to completely to stop themotor and blade. Alwayslet themotor/blade come to
acomplete stop before starting themotor again.
2. Remove thesafety key (15) when you have finished mowing.
4.4 Setting the cutting height
• Adjust cutting height in relation to grass height. Startwith ahigh cutting height and adjust accordingly for
thebest results. NOTE: Alwaysturn off themower and let therotating blade come to acomplete stop
before adjusting thecutting height.
• There are 5 cutting height settings: 1 = 30 mm (short grass length) to 5 = 65 mm (higher grass length).
• Adjust cutting height by pushing theheight lever (12) inwards towards thebattery until it releases. Adjustto
thedesired cutting level. Pushthehandle outwards to thedesired setting and ensure that it locks into position.
• When cutting grass for thefirst time at thebeginning of theseason, themower should be set to arather
high setting in relation to grass height in order to ensure proper healthy growth of your lawn. Thereafter,
thecutting height can be adjusted according to desire. Remember that shorter cutting lengths will shorten
thebattery life’s mowing time.
5. Maintenance
NOTE: Alwaysdisconnect thesafety key (15) from themower before starting maintenance or servicing.
• Clean themower with abrush or cloth after eachuse.
• Never spray off themower with water to clean it. Doingso may damage themower’s electrical components.
• Tighten all nuts and screws to ensure that themower is in good safe working order.
• Before using make sure to check all electrical equipment. Ifthere is any damage to cables, fittings or
anything else themower must not beused.
• Always use original parts. Non-original parts can present arisk for injury even if they should fit themower.
• Always change any damaged warning and instructional decals.

CO/Tech MOR-LR01-370 Specifications

General

Brand	CO/Tech
Model	MOR-LR01-370
Category	Lawn Mower
Language	English