START UP GUIDE
Oasis Package
PREP
FOR
FILLING
! PLEASE READ ALL INSTRUCTIONS BELOW BEFORE FILLING THE SPA
Using a cloth and water, wipe away
any dirt/dust collected from
transport. Ensure all jets are open by
turning the face counterclockwise.
Ensure all plumbing and electrical
connections are securely connected
and tightened as they can come
loose during transit.
Ensure
that
any
gate/knife
valves
are fully open.
Remove the filter lock ring and lid.
Remove
filter
and
take
it
out
of
the
plastic transport bag. Leave filter
canister open when filling.
Remove
skimmer
cavity
grate
cover
by sliding it upwards.
Loosen (do not remove) the air
bleeder valve located in the
skimmer cavity.
FILLING YOUR SPA
! DO NOT USE HOT WATER TO FILL YOUR SPA
! DO NOT USE WATER FROM A WATER SOFTENER
Place fill hose into
open filter
canister
and fill hot tub until water is 2/3 of the
way up the skimmer opening.
When filled all massage jets
(excluding neck jets) should be under
water.
Remove fill hose from filter canister.
Put filter back
into filter canister.
Then
put back on the filter canister lid and
tighten locking ring.
POWERING UP YOUR SPA
Turn the power
on
at the
main
breaker.
Turn pump 1 on high speed for
20 seconds by pressing the pump
icon twice.
Turn pump 1 off by pressing the
pump one icon once. Repeat steps 2
and 3 until air is removed from
pump 1 and water is coming from
jets.
Tighten
the
air
bleeder
valve
located
in
the skimmer cavity. Set your hot tub
temperature. Get ready to enjoy!
To Next Page
Loading...
