MODL (System Model) Displays the Model Number of the
System.
SETP (Current Setup) Displays the currently selected
Configuration Setup Number.
Heater Voltage (Feature not used on CE rated systems.) Displays
the operating voltage configured for the heater.
Heater Wattage as Configured in Software (CE Systems Only.)
Displays a heater kilowatt rating as programmed into the control
system software (1-3 or 3-6).
H _ (Heater Type) Displays a heater type ID number.
SW_ (Dip Switch Settings) Displays a number that represents the
DIP switch positions of S1 on the main circuit board.
PANL (Panel Version) Displays a number of the
software in the topside control panel.
Additional Utilities
Utilities in addition to INFO, The Utilities Menu contains the
following:
GFCI (GFCI Test) (Feature not available on CE rated systems.)
GFCI Test is not always enabled, so it may not appear. This
screen allows the GFCI to be tested manually from the panel and
can be used to reset the automatic test feature. If the GFCI Test
Feature is reset, the device will trip within 7 days.
A / B (A/B Sensor Temperatures) When this is set to On, the
temperature display will alternate to display temperature from
Sensor A and Sensor B in the heater.
FALT LOG (Fault Log) The Fault Log is a record of the last 24
faults that can be reviewed by a service tech.
DEMO (Demo Mode) Demo Mode is not always enabled, so it
may not appear. This is designed to operate several devices in a
sequence to demonstrate the various features of a particular hot
tub.
To Next Page
Loading...
