Need help?Do you have a question about the COBHAM 7023A and is the answer not in the manual?
Steps for experienced personnel to configure the SAILOR XTR Ka system for on-air use.
Key factors to consider for optimal system performance and safe installation.
Information on safety distances due to microwave radiation hazards from the ADU.
Recommendations for maintaining separation distances to avoid interference and potential damage.
Step-by-step instructions for installing the 100 cm Above Deck Unit (ADU).
Step-by-step instructions for installing the 60 cm Above Deck Unit (ADU).
Detailed steps for connecting the antenna, BDU, and modem units using various cables and interfaces.
Overview of the web interface used for setting up the SAILOR XTR Ka system.
Steps to establish a connection to the system's web interface using a PC and browser.
Configuration options for VSAT profiles, network, navigation, IoT, user administration, and installation wizard.
Procedure for setting up and activating VSAT profiles, including modem and satellite data.
Configuration steps for supported modem types, including SAILOR GX Modem and Generic Modem.
Configuration of network settings for BDU and ADU LAN ports, including IP and gateway setup.
Setting up heading and position modes for antenna calibration and operation.
Defining blocking zones to optimize performance by managing transmission and signal blockage.
Step-by-step guidance through the system setup process using the installation wizard.
Managing software, calibration, commissioning, events, support, and troubleshooting.
Managing software versions, uploading, saving configurations, and resetting to factory defaults.
Detailed instructions for azimuth and cable calibration required for optimal system performance.
Performing manual One Touch Commissioning for modem and BUC calibration.
Steps to perform a line-up to fine-tune the TX polarization unit for optimal performance.
A checklist to verify proper installation of the antenna, covering obstructions, safety, and mounting.
Checklist to verify correct installation and connection of the BDU, VSAT modem, and related wiring.
Steps for performing a functional test in harbor to ensure the system is ready for operation.
Information on the built-in test equipment (BITE) and LED indicators for diagnostics.
General guidelines for initial troubleshooting, observing LEDs, and understanding possible failure states.
Procedure to gain temporary administrator access if the password is forgotten.
Detailed technical specifications for the SAILOR 1000 XTR Ka 100 cm antenna system.
Detailed technical specifications for the SAILOR 600 XTR Ka 60 cm antenna system.
Steps for installing the dual antenna system, including system overview and physical installation.
Detailed steps for installing master and slave antennas, BDU, modem, and connecting cables.
Configuration steps for master and slave BDUs, including VSAT profiles, blocking zones, and OTC.
Steps to configure the Master BDU for dual antenna operation, including network and VSAT profile settings.
Steps to configure the Slave BDU to work with the Master BDU as a dual antenna system.
Recommendations for setting up blocking zones in each antenna for optimized dual antenna operation.
Procedure for performing One Touch Commissioning for dual antenna systems.
Strategies for optimizing system performance when encountering signal blockage.
Reference for available commands in the User Command Line Interface (UCLI) for system management.
Commands to retrieve system status, tracking parameters, and event lists.
Reasons for grounding the system, including safety and ESD protection.
Detailed recommendations for grounding the BDU and ADU to the ship's hull or dedicated ground points.
Procedure for grounding the BDU using a short ADU cable and grounding stud.
Procedure for grounding the ADU via its mounting bolts, ensuring electrical contact.
A comprehensive list of event IDs, modules, types, descriptions, and explanations for troubleshooting.
To Next Page
General