COBHAM AVIATOR UAV 200 - Installation Tools and Equipment; Required Tools List

AVIATOR UAV 200
Installation Manual
Document: 677-A0219_IM issue 1.4
COBHAM PUBLIC
Page 23 of 61
6. SPECIAL TOOLS, FIXTURES AND EQUIPMENT
Tools, fixtures and equipment necessary to perform the AVIATOR UAV 200 installation is described in this
manual refer to Table 6-1, below. Equivalent substitutes may be used.
Table 6-1: Tools, Fixtures and Equipment Required for the AVIATOR UAV 200 Installation
Name
Specification or part number
Source /CAGE code
Section
1
Milliohm meter
Extech 380460 Series
(typical)
Extech Instruments
Corporation, 285 Bear
Hill Road, Waltham, MA
02451-1064 Cage code
0LTF4
Installation: To install
the SATCOM system.
2
Torque driver
3.5 – 5 Nm (2.6-3.7 ft-lb)
Commercially available
Installation: To install
the SATCOM system.
3
Crimp tool
DANIELS MH800 with K1692
positioner
Commercially available
External Interfaces:
To install the
SATCOM system.
4
Pin Insertion /
Extraction Tool
Insert Tool C12935
Extraction Tip for female contact
13170
Extraction Tip for male contact
13242
Insertion Tip for AWG 24-28 (S)
13171
Insertion Tip for AWG 22 © 13172
Nicomatic
External Interfaces:
To install the
SATCOM system.