Chapter 4: Using the Terminal Control Unit
Configuration 39
44444
Using the Terminal
Reset button for IP address
The TCU has a button for setting a temporary fixed IP address. When you
push the button, the IP address of the TCU is temporarily set to the default
value (169.254.100.100). For further details see Setting a temporary fixed
IP address on page 63.
Configuring SSA buttons
Configuration of the SSA buttons lies in the SAILOR 3027. To access these
settings enter the terminal program as described in Using commands on
page 35 and type:
minic
The prompt changes to (example): can0:/$
Configuring SSA recipients
If your system uses SSA buttons, the SAILOR 3027 must be configured with
the recipient(s) of the Ship Security Alert. The recipients must be selected
according to the Flag Administration under which the vessel is sailing. The
recipients can be:
• e-mail addresses
• phone numbers (SMS)
• fax numbers
• telex numbers.
Specifications of the SSA routing requirements are found in IMO SOLAS
Regulation XI-2/6 and in IMO Circulars MSC/Circ.1072 and MSC/Circ.1073.
To configure the SSA recipients in the connected SAILOR 3027, do as
follows:
1. Connect a computer and access the SAILOR 3027 settings as described
in the previous section Using commands.
2. Enter the command for configuration of SSA recipients.
To Next Page