Chapter 2: Operation
List of alarms 43
22222
Operation
Rx channel
AIS 1
malfunction
(ID 003)
The SAILOR 6282
AIS Transponder
stops
transmission on
the affected
channel.
If continuous monitoring of
the receiver channel 1
shows inconsistency, this
alarm is activated.
Check the VHF
antenna, plugs,
and cable to the
AIS transceiver.
Rx channel
AIS 2
malfunction
(ID 004)
The SAILOR 6282
AIS Transponder
stops transmitting
on the affected
channel.
If continuous monitoring of
the receiver channel 2
shows inconsistency, this
alarm is activated.
Check the VHF
antenna, plugs,
and cable to the
AIS Transponder.
Rx channel 70
malfunction
(ID 005)
The SAILOR 6282
AIS Transponder
continues
operation, but
external channel
management is
not possible.
If continuous monitoring of
the receiver channels shows
inconsistency, this alarm is
activated.
Check the VHF
antenna, plugs,
and cable to the
AIS Transponder.
General failure
(ID 006)
The SAILOR 6282
AIS Transponder
stops functioning.
In case of severe
software or
hardware failure,
this alarm is
activated.
Check the power
supply to the AIS
Transponder.
UTC sync
invalid
(ID 007)
The SAILOR 6282
AIS Transponder
continues
operation using
indirect or
semaphore
synchronization.
If the internal GNSS
receiver cannot receive a
synchronization signal from
the satellites, this alarm is
activated.
Check the GNSS
antenna, plugs,
and cable to the
AIS Transponder.
Alarm Consequence Reason Remedy
Table 9: AIS Alarms (Continued)
To Next Page
Loading...
